Best Cheap Spectacle Spade Blind Pipe Flange Ansi 16.5 A182 Quotes – Forged Weld Neck Flange – C. Z. IT

SPECIFICATION

DIMENSION STANDARDS

PRODUCTS DETAIL SHOW

1. Face
Can be raised face(RF), full face(FF), Ring joint(RTJ) , Groove, Tongue, or customized.

2.Bevel end as per ANSI B16.25

3.CNC fine finished.
Face finish: The finish on the face of flange is measured as an Arithmetical Average Roughness Height(AARH). The finish is determined by the standard used. For example, ANSI B16.5 specifies face finishes within a range 125AARH-500AARH(3.2Ra to 12.5Ra). Other finishes are available on requst, for example 1.6 Ra max,1.6/3.2 Ra, 3.2/6.3Ra or 6.3/12.5Ra. The range 3.2/6.3Ra is most common.

MARKING AND PACKING

• Each layer use plastic film to protect the surface

• For all stainless steel are packed by plywood case. For bigger size carbon flange are packed by plywood pallet. Or can be customized packing.

• Shipping mark can make on request

• Markings on products can be carved or printed. OEM is accepted.

INSPECTION

• UT test

• PT test

• MT test

• Dimension test

Before delivery, our QC team will arrange NDT test and dimension inspection.Also accept TPI(third party inspection).

PRODUCTION PROCESS

COOPERATION CASE

A project in Turkey, flanges are used in natural gas pipelines. All those flanges are approved by TUV.

FLANGE DATA SHEET

1. Flange dimensions and tolerances shall be according to ASME B16.5.
2. Flanges shall be produced by forging.
3. Materials shall be according to ASTM A105, ASTM A694 F65 and ASTM A694 F70 standards.
4. ASTM A694 F65 and ASTM A694 F70 flanges shall be quenched and tempered.
5. Material test certificates and heat treatment reports shall be made available for TPI inspections.
6. WN flanges shall be with bevel ends acc. to ASME B16.25.
7. Materials chemical and mechanical test values(impact, yield,tensile etc.)shall be according to related standards.
8. All surfaces shall be machined and varnished with a transparent oil to prevent rusting.
9. Marking shall include the following information,

• Diameter (exp. 6”)
• Pressure class (exp. 150 LB)
• Material Grade (exp. ASTM A 105)
• Wall thickness (exp. 4,78 mm)
• Heat No (exp. 138413)
• Production standard (ASME B16.5)

10. Materials shall be free from any surface defects and cracks. Welding repairs are strictly forbidden.
11. All flanges shall be raised face (RF) with sealing surface. Sealing surface shall be Ra 3,2 – 6,3 µm (125 – 250 mic. inc.) acc. to ASME B46.1.
12. Materials shall be packed to prevent damages to machining, and sealing surfaces.
13. All dimensions shall be in positive (+) tolerances. Minus tolerances are strictly forbidden.
14. Flange bevellings shall be made acc. to ASME B16.25.
15. Manufacturing process will be checked at any time by TPI.
16. TPI may take samples from any material for chemical/mechanical test sample.
17. Incoming inspection report shall be reviewed by TPI.